Step One
|
First you will need tape of a width of 1 inch. Place a strip of that tape about 6 inches in length on a clean surface to cut.
|
Step Two
|
Next get a razor blade or x-acto knife and CAREFULLY cut the strip of tape in half.
|
Step Three
|
Now peel that strip of tape from the surface slowly so that it does not lose its stickyness.
|
Step Four
|
Using your Thumb, index, and middle finger, pull the skin up over the head of your glans.
|
Step Five
|
Now once you have the skin pulled over, take the strip of tape ion your other hand and start to put it
on the shaft of your penis about 1/8 of an inch from the tip of the finger that is holding the skin back.
|
Step Six
|
Work the tape fully around the shaft. The first time you do this it might be hard, it takes a bit of
practice to get this down. Make the tape ring a little tight so that it will stay in place through
out the day, DONT MAKE IT TOO TIGHT.
|
Step Seven
|
Ok, almost done! Now you will have some excess tape. Make sure the ring you just applied is nice and
stuck to the other side of the ring.
|
Step Eight
|
For this step you will need to get a pair of scissors. NOW VERY CAREFULLY cut away the excess
tape. Try not to get your finger prints on the sticky part of tape because once you are done, the ring
will not stay in place because the adhesive of the tape is dirty from the oils on your skin.
|
Step Nine
|
This rest of the tape, stick it to the ring of tape that is already applied.
|
Step Ten
|
Now your all done!!!!.
|
|
|
Why should I use the tape
ring method?